R440458 Size: 4000 Features: -Easy-to-open shell surrounds pump to significally reduce maintenance.-Double protection from clogging with internal prefilter grid.-Vortex designed impeller for dirty water.-Comes with four different changeable spray nozzles.-Built-in flow regulation.-Bottom of shell closed to keep debris out.-Diverter valve to operate two different water features.-ideal for using with an external filter. Dimensions: -2400 Pump: 650 GPH; 8.2 feet Shut-off Height; 55 Watts; 1'' Discharge.-4000 Pump: 1004 GPH; 8.5 feet Shut-off Height; 75 Watts; 1'' Discharge.-5000 Pump: 1268 GPH; 14 feet Shut-off Height; 110 Watts; 1'' Discharge.
  • Shell surrounds pump to significantly reduce maintenance, Easy to open shells with locking clips
  • Includes Vortex designed impeller for dirty water and Wide range of nozzles, flow regulation and easy grip handle
  • Diverter valve to operate two different water features
  • Additional features: Top or side discharge, ideal when using an external filter
  • Adjustable internal grid and Venturi oxygenation device

Write a review

Note: HTML is not translated!
    Bad           Good

Lifegard Aquatics R440458 Caged Pond Pump, Model 1004

  • $254.77

Available Options

Dynamic Head

The effect of the Earths gravity on the "lift" or head pressure is fairly simple; for every vertical foot of distance the pump moves the water you are adding one foot of head pressure so the ratio is a 1:1 ratio. The effects of the friction, caused by water as it travels through your hose or pipes, on the total head pressure is a little more difficult to calculate especially as there are slight variations in pipe friction in different hose materials and the smoothness of the inner bore. Basically. for every ten feet of pipe through which the water has to travel travel horizontally will contribute 1 foot of head height; the ratio of the pipe friction loss is a 10:1 ratio.

Plumbing fixtures and bends and corners in your hose also increase the total head you must calculate to ensure the proper final volume from your pump. Every corner with a 90 degree elbow in your plumbing will add 1 foot of head pressure  with a 1:1 ratio. 45 degree elbows, tees and even insert couplers can all have an impact on the final flow.

If you install a pump 40 feet away from the top of your waterfall which is 6 feet above the pump and the tubing is a single run of 40 feet horizontally then you add 4 feet of head for the tubing length (the 10:1 ratio) to the 6 foot differnetial between the pump location and the final height of the waterfall so your final total dynamic head calculation would be 10 feet. This means your final volume of water flow in this water feature or application would be the volume of flow on the performance curve that equaled the gallons per hour at 16 feet. This volume will certainly be much less than the initial volume the pump can move at an open flow or a zero head.

If in the above example your 40 feet of horizontal tubing run also required 3 elbows of 90 degrees then an additional 3 feet of theoretical head would be added and your final flow result would be at 19 feet on the performance curve of the pump. In this example you would want to choose a pump that has the desired GPH rating at 9 feet of head pressure.  Tubing size is also an important factor in accounting for head pressure loss, in general you should never reduce the diameter of the tubing below what the output size of the pump is, this will drastically increase head pressure, and reduce pump performance.  For maximum pump performance, using the largest tubing that is practical is the best choice. A best practice is to use a hose with an inner diameter that is the same as your pumps outlet fitting.

eXTReMe Tracker